Wheels Penetrating Object and Car Body???

Got questions, comments and/or feedback regarding Craft Director Studio? Post them here.
Forum rules
We only allow posts that
  • Is in English
  • Is related to our tools and the programs they support.

If these rules are not met you are most likely going to be banned.

Please Note:
  • New users will have their posts reviewed before being publicly available for other to see.
Post Reply
skobot22
Posts: 1
Joined: Fri Dec 09, 2011 9:59 am

Wheels Penetrating Object and Car Body???

Post by skobot22 » Fri Dec 09, 2011 10:22 am

Hello

I need to do a close up of a wheel going over an object but wheels are penetrating it.Also they are penetrating the car body mesh.
Please help me I recently purchased Craft Directors Studio so this is all very new to me.
Top
Patrik Martin
Partner
Posts: 416
Joined: Mon Feb 25, 2008 1:07 pm
Location: Gothenburg, Sweden
Contact:
Contact Patrik Martin

Re: Wheels Penetrating Object and Car Body???

Post by Patrik Martin » Wed Dec 14, 2011 10:12 am

In the configuration for the 4-Wheeler Extended you are able to change the values in the Ray Multiplier group. Add a couple of rays and edit the degrees and you will get a more detailed ground detection. Usually it is good to have a lower value at first and then make the changes and click on re-simulate when you are done with the path of the car.
Partner
http://www.craftanimations.com
patrik.martin-at-craftanimations.com
Top
Post Reply

Return to “Craft Director Studio - Help, Feedback and more”

Who is online

Users browsing this forum: No registered users and 50 guests