I have aproblem with the backwheels and autonous mode (Max2009/64).
They are turning like the front wheels, not as much as the front but to much.
Back wheels 4wheel ext
Forum rules
We only allow posts that
If these rules are not met you are most likely going to be banned.
Please Note:
We only allow posts that
- Is in English
- Is related to our tools and the programs they support.
If these rules are not met you are most likely going to be banned.
Please Note:
- New users will have their posts reviewed before being publicly available for other to see.
Back wheels 4wheel ext
Hallo
I have aproblem with the backwheels and autonous mode (Max2009/64).
They are turning like the front wheels, not as much as the front but to much.
I have aproblem with the backwheels and autonous mode (Max2009/64).
They are turning like the front wheels, not as much as the front but to much.
-
Carl Buhre
- Quality Assurance Consultant
- Posts: 438
- Joined: Mon Feb 25, 2008 12:59 pm
- Location: Gothenburg, Sweden
- Contact:
Re: Back wheels 4wheel ext
Hello Dietmar.
This is happening because of the position of your TurnBaseMesh. Adjust the value so that it's positioned at the back axle of your vehicle.
You can find the setting for the TurnBase in Craft 4-Wheeler Extended's configuration window. In the Steering Parameters group, there's a setting called "Turn Base (Back Wheel Relative)". Change this value and look at the viewport for a change. Change the value until the TurnBase is in the correct position.
This is happening because of the position of your TurnBaseMesh. Adjust the value so that it's positioned at the back axle of your vehicle.
You can find the setting for the TurnBase in Craft 4-Wheeler Extended's configuration window. In the Steering Parameters group, there's a setting called "Turn Base (Back Wheel Relative)". Change this value and look at the viewport for a change. Change the value until the TurnBase is in the correct position.
Who is online
Users browsing this forum: No registered users and 43 guests