Craft and CAT working together

Share your Craft Director Studio creations or work-in-progress here.
Forum rules
We only allow posts that
  • Is in English
  • Is related to our tools and the programs they support.

If these rules are not met you are most likely going to be banned.

Please Note:
  • New users will have their posts reviewed before being publicly available for other to see.
Post Reply
wellander
Posts: 10
Joined: Fri May 16, 2008 5:58 pm

Craft and CAT working together

Post by wellander » Tue Oct 13, 2009 6:27 pm

Wanted to see how fast and easy it would be to animate a lizard rig from CAT with Craft.
http://www.planet11.com/3d/odlan_hoppar.rar
Answer is easy :)

(the tail is uses a spring controller setup)
Top
Carl Buhre
Quality Assurance Consultant
Posts: 438
Joined: Mon Feb 25, 2008 12:59 pm
Location: Gothenburg, Sweden
Contact:
Contact Carl Buhre

Re: Craft and CAT working together

Post by Carl Buhre » Wed Oct 14, 2009 9:08 am

Hehe, nice work Wellander! What tools did you use?
Top
wellander
Posts: 10
Joined: Fri May 16, 2008 5:58 pm

Re: Craft and CAT working together

Post by wellander » Tue Oct 20, 2009 9:38 pm

I used 4 the 4 wheel drive to create the motion. Then not that it has anything to do with your tools. I created two layers of animation for the CAT rig. Both using cat motion one assigned to lock the feet to the surface and one "free" that's why it "runs" in the air. I am aware that it's totally rough. But for me it was a proof of concept and I pput it together in no time.

I keyframed the cam cos it was really quick and dirty. Sorry I know I should have used yours :)
Top
Post Reply

Return to “User-created content”

Who is online

Users browsing this forum: No registered users and 8 guests