[2 Wheeler Ext] REAR SUSPENSION SETUP

Got questions, comments and/or feedback regarding Craft Director Studio? Post them here.
Post Reply
UPRAWorker
Posts: 1
Joined: Tue Oct 11, 2011 5:42 pm

[2 Wheeler Ext] REAR SUSPENSION SETUP

Post by UPRAWorker » Tue Oct 11, 2011 6:12 pm

Hi, I'm trying to rig the rear suspension but I have a problem:

The swing arm should rotate from the center of the chassis and do not know how to do it .. I have separate parts:

- Chassis
- Handlebar
- Front mudguard
- Wheels
- Swingarm (chain, etc. ..)

I need the tool "Gyro"? and if so .. how do I use?

Thank you very much!

Patrik Martin
Partner
Posts: 321
Joined: Mon Feb 25, 2008 1:07 pm
Location: Gothenburg, Sweden
Contact:

Re: [2 Wheeler Ext] REAR SUSPENSION SETUP

Post by Patrik Martin » Mon Oct 24, 2011 4:41 pm

You can use the free Suspension tool that is included in CDS to rig the swing arm. Make the Upper part a child of the Body, the Lower a child of the WheelCenterMesh and the swing arm a child of the "spring". Make sure to initialize the suspension from the configuration before you connect something to it.
Partner
http://www.craftanimations.com
patrik.martin-at-craftanimations.com

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests