Speed Spline Controller

Got questions, comments and/or feedback regarding Craft Director Studio? Post them here.
Post Reply
jigi525
Posts: 6
Joined: Thu Dec 16, 2010 1:57 pm

Speed Spline Controller

Post by jigi525 » Tue Jan 18, 2011 2:39 pm

hi,

I'm using craft director 10.1.2. Currently I'm working on Speed Spline controller. I activate the Autonomus - tight mode in it.....At low speeds the 4-wheeler extended is following the carriage tightly....but on increasing the speed of the waypoints, the carriage increases its speed but the 4 wheeler extended gets left behind and follows slowly......tried other profiles too but no luck...Can anyone help me achieve a tightly following 4 wheeler extended configuration.?? What values need to be manipulated for it?? The Autonomous Mode Follow Strength and the Follow Strength Response Factor don't seem to help... :( :(
Need to work on the project ASAP !!!

Thanxx :)

Patrik Martin
Partner
Posts: 322
Joined: Mon Feb 25, 2008 1:07 pm
Location: Gothenburg, Sweden
Contact:

Re: Speed Spline Controller

Post by Patrik Martin » Tue Jan 18, 2011 2:42 pm

For the 4-Wheeler Extended increase the Gas Pedal (Forw/Backw) value in the configuration. That should make it catch up.
Partner
http://www.craftanimations.com
patrik.martin-at-craftanimations.com

Post Reply

Who is online

Users browsing this forum: Keganbep and 1 guest