Got questions, comments and/or feedback regarding Craft Director Studio? Post them here.
Forum rules
We only allow posts that
- Is in English
- Is related to our tools and the programs they support.
If these rules are not met you are most likely going to be banned.
Please Note:
- New users will have their posts reviewed before being publicly available for other to see.
-
jigi525
- Posts: 6
- Joined: Thu Dec 16, 2010 1:57 pm
Post
by jigi525 » Tue Jan 18, 2011 2:39 pm
hi,
I'm using craft director 10.1.2. Currently I'm working on Speed Spline controller. I activate the Autonomus - tight mode in it.....At low speeds the 4-wheeler extended is following the carriage tightly....but on increasing the speed of the waypoints, the carriage increases its speed but the 4 wheeler extended gets left behind and follows slowly......tried other profiles too but no luck...Can anyone help me achieve a tightly following 4 wheeler extended configuration.?? What values need to be manipulated for it?? The Autonomous Mode Follow Strength and the Follow Strength Response Factor don't seem to help...

Need to work on the project ASAP !!!
Thanxx

-
Patrik Martin
- Partner
- Posts: 416
- Joined: Mon Feb 25, 2008 1:07 pm
- Location: Gothenburg, Sweden
-
Contact:
Post
by Patrik Martin » Tue Jan 18, 2011 2:42 pm
For the 4-Wheeler Extended increase the Gas Pedal (Forw/Backw) value in the configuration. That should make it catch up.
Partner
http://www.craftanimations.com
patrik.martin-at-craftanimations.com
Who is online
Users browsing this forum: No registered users and 12 guests