Autonomous

Got questions, comments and/or feedback regarding Craft Director Studio? Post them here.
Post Reply
masterfx
Posts: 1
Joined: Mon Mar 16, 2009 10:11 pm

Autonomous

Post by masterfx » Mon Mar 16, 2009 10:18 pm

I am trying to make a car follow CV spine that starts at 100% velocity. The rig follows the spline just fine but it falls behind initially so my pre-built scene is off.
So I am stumped on how to make the car follow the target mesh at the same speed throughout the 150 frames. Again I am using the Autonomous mode and at this
point I cant get any settings correct.

Thanks

Carl Buhre
Quality Assurance Manager
Posts: 433
Joined: Mon Feb 25, 2008 12:59 pm
Location: Gothenburg, Sweden
Contact:

Re: Autonomous

Post by Carl Buhre » Tue Mar 17, 2009 10:47 am

Hello Masterfx and welcome to our forum.

If you enter the configuration window for Craft 4-Wheeler Extended and increase the value for "Gas Pedal (Forw/Backw) Maximum", you will increase the maximum speed of the vehicle. This will make it easier for the vehicle to keep up with the target.

Nariman1234
Posts: 1
Joined: Sun Mar 24, 2013 2:06 pm

Re: Autonomous

Post by Nariman1234 » Sun Mar 24, 2013 2:46 pm

Hi again. Dear Sir how can we decrease the speed of Target Mesh instead of increasing the velocity of car? Because if we increase the speed of car as much as target mesh speed, the view comes to be unreal!
best regards,
Nariman

camila
Posts: 1
Joined: Tue Sep 09, 2014 2:53 pm

Re: Autonomous

Post by camila » Wed Sep 10, 2014 7:08 am

I just did a quick forum search for "car animation" and I came across this thread. Especially for two years ago, this animation is outstanding. Way to take advantage of your resources and make a compelling project.
camila

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests