Page 1 of 1
4 Wheller ext - question (parent breaking system)
Posted: Tue Jun 03, 2008 3:26 pm
by Randevous
Hi All !!! please help
To what object parent (braking system) that it did not turn, and accompanied in accuracy a wheel?
thnx!
Re: 4 Wheller ext - question (parent breaking system)
Posted: Tue Jun 03, 2008 3:30 pm
by Carl Buhre
Hello Randevous and welcome to our forum. I'm not sure I understand your question but I think what you're looking for is the WheelCenterMesh (WheelerExt_01_WheelCenterMesh_FR, WheelerExt_01_WheelCenterMesh_FL, WheelerExt_01_WheelCenterMesh_BR & WheelerExt_01_WheelCenterMesh_BL).
Re: 4 Wheller ext - question (parent breaking system)
Posted: Tue Jun 03, 2008 3:52 pm
by Randevous
The matter is that at me is hires a wheel, and in a wheel there are details for example (support system) any (breaking disk) - which do not turn together with a wheel but only repeat its movement.
How to me to make so that breaking disk did not take off from a wheel at turn?
Forgive for my bad English language
))
Re: 4 Wheller ext - question (parent breaking system)
Posted: Tue Jun 03, 2008 4:07 pm
by Carl Buhre
Ah ok, for that you can utilize Craft Gyro which is a part of Craft Free Utilities.
- Scale Craft Gyro to a proper size. Its size doesn't have any effect, it's just to make it easier to see.
- Align it to the WheelCenterMesh.
- Parent Gyro_01_pivot to the WheelCenterMesh.
- Then parent the support system/breaking system to Gyro_01_gyro.
Finally enter the configuration of Craft Gyro and select restriction: "Pitch only" (I might be wrong here, if it didn't work try another restriction) and press Resimulate.
Re: 4 Wheller ext - question (parent breaking system)
Posted: Tue Jun 03, 2008 4:17 pm
by Randevous
Thanks your help!!!
Re: 4 Wheller ext - question (parent breaking system)
Posted: Wed Jun 04, 2008 9:46 am
by Carl Buhre
No problem, I hope it helped. If you run into any other problems please post them.