Resimulate with different ground?

Got questions, comments and/or feedback regarding Craft Director Studio? Post them here.
Forum rules
We only allow posts that
  • Is in English
  • Is related to our tools and the programs they support.

If these rules are not met you are most likely going to be banned.

Please Note:
  • New users will have their posts reviewed before being publicly available for other to see.
Post Reply
Posts: 1
Joined: Tue Mar 26, 2013 11:31 pm

Resimulate with different ground?

Post by trevorroth » Tue Mar 26, 2013 11:42 pm

This question could be asked several ways, but here's a scenario I run into sometimes. I've animated the vehicle driving on rough terrain using a keyboard/joystick, etc., and the client has signed off on the timing and general positioning... BUT, they'd like to see it with the ground a little "less rough".

Is there a way to swap out my ground surface and re-simulate without having to "re-drive" the vehicle, but instead relying on the input values already recorded (up arrow for 10 seconds, left arrow for 2.5, brake here, skid there, etc.)? I understand that the resulting animation (distances traveled, turn radius, etc.) could be different, but the general question still exists.

I apologize if this is covered somewhere, but I couldn't find it.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest